Send
.....
filename:
Load
Save
/* Blink Turns on an LED on for one second, then off for one second, repeatedly. Лампа МН 6.3-0.3 Е10/13 DS18B20 This example code is in the public domain. */ // Pin 13 has an LED connected on most Arduino boards. // give it a name: int led = 13; // the setup routine runs once when you press reset: void setup() { // initialize the digital pin as an output. pinMode(led, OUTPUT); } // the loop routine runs over and over again forever: void loop() { digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level) delay(1000); // wait for a second digitalWrite(led, LOW); // turn the LED off by making the voltage LOW delay(1000); // wait for a second }
Arduino UNO
ESP8266
Compile the Code!
Upload!
RUN
device_info
device_message
Input
Output
Output(PWM)
None
ON
OFF
Input
Output
Output(PWM)
None
ON
OFF
Input
Output
Output(PWM)
None
ON
OFF
Input
Output
Output(PWM)
None
ON
OFF
Input
Output
Output(PWM)
None
ON
OFF
Input
Output
Output(PWM)
None
ON
OFF
Event messages: